Message
 Conatact Us
TEL:+086-0769-8201-7148
FAX:+086-0769-8201-7780
E-mail:ken13608@gmail.com

MSN:ken52103@hotmail.com
















Home >> Message
    Instead of using sand as the mold material, a metal is used as a mold. Typically cast iron or Meehanite (a dense cast iron) is used as the mold material and the cores are made from metal or sand. Cavi
    Investment casting is also known as the lost wax process. This process is one of the oldest manufacturing processes. The Egyptians used it in the time of the Pharaohs to make gold jewelry (hence the n
    Full-mold casting is a technique similar to investment casting, but instead of wax as the expendable material, polystyrene foam is used as the pattern. The foam pattern is coated with a refractory mat
12-6-8  Forging
    Forging is the process by which metal is heated and is shaped by plastic deformation by suitably applying compressive force. Usually the compressive force is in the form of hammer blows using a power
12-6-5  Extrusion
     Extrusion is the process by which long straight metal parts can be produced. The cross-sections that can be produced vary from solid round, rectangular, to L shapes, T shapes. Tubes and many oth
12-6-5  Die-casting
     Die-casting is similar to permanent mold casting except that the metal is injected into the mold under high pressure of 10-210Mpa (1,450-30,500) psi . This results in a more uniform part, genera
     Similar to plaster mold casting, the pattern used in ceramic mold casting is made of plaster, plastic, wood, metal or rubber. A slurry of ceramic is poured over the pattern. It hardens rapidly t
    Centrifugal casting as a category includes Centrifugal Casting, Semi-Centrifugal Casting and Centrifuging. Centrifugal Casting: In centrifugal casting, a permanent mold is rotated about its axis at
    1. (a) Cold Cleaning Degreasing. On or after September 6, 2009, no person owning, operating, leasing or controlling any solvent metal degreasing facility which utilizes a cold cleaning degreaser
    means the use of degreasers: (a) To clean metal parts used in the manufacturing and rework of electronic parts, assemblies, boxes, wiring harnesses, sensors and connectors used in aerospace service;
    Cold cleaning degreasing means the batch process of solvent metal cleaning by spraying, brushing, flushing or immersion while maintaining the solvent below its boiling point. Wipe cleaning is not incl
    EPA has new requirements to reduce air pollution of compounds of metals such as cadmium, chromium, lead, manganese and nickel from nine metal fabrication and finishing source categories.   T